9/5/2023 0 Comments Elumatec sbz 130 manual![]() Tested all i could think off but no matter what, it gives fuzzy readings, and at a certain point in rotation, it just stops sending pulses, so i gues it must be lower/upper type. Long X axis is 4096x4096 but has another wire fro direction.įound the above attached pdf, so they are SSI and grey code, also the frequency is recomended to be at 200kHz. Spindle encoder is 4096 counts per revolution but can count only one rotation. Not to be mistaken for counts per revolution.Īxis encoders are 4096 counts per revolution and can count up to 4096 rotations. This is with the spimdle encoder, same typea are on all axis except the long X, but different revolution counts. Yes that is what i get, and i can see the pulses with halscope, tested for 3 hours today to get something useful out of it but no luck.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |